Why a screen proof is not enough
A colour on a monitor is emitted light; a colour on fabric is reflected light through a dyed or coated surface. The same hex value looks different on a phone, a paper proof and a compressive knit, and none of those shows how the bib behaves in daylight or under floodlights.
For a club or team bib, the colour has to work as a set: leg panel, mesh upper, gripper band, binding tape and thread. Each material takes colour differently, so each is approved as part of the same reference, not as an isolated artwork file.
That is why the approval step is a physical swatch or a decorated panel, not a PDF.
Base shade and sublimation
Dye sublimation prints into the fabric, so the base shade is part of the final colour. A bright white base reads cooler and more saturated; a tinted base warms the same artwork. On dark bases, the artwork needs more density to hold its value.
This matters most on light colours - pale grey, sky blue, mint and white panels - where a small shift in the base is visible across a large thigh panel. It matters on gradients too, where the transition has to stay smooth on the actual knit.
The approved sample should be made from the production fabric, not from a substitute that happens to be in the sample room.
How a colour is approved
The method depends on the finish. Solid fabrics are matched with a lab dip; sublimated panels are checked with a strike-off printed on the production base. Both are compared against your reference under controlled light.
Two checks are worth doing:
- Daylight and indoor light: a colour that matches at the window can shift under warm indoor lighting.
- Side by side: compare the swatch with the reference on the same surface, not from memory or from two screens.
Once approved, the swatch is labelled and kept with the order file. That is the reference the bulk fabric check is measured against.
Matching the whole bib
The leg panel and the mesh upper are different knits: a compressive knit against an open mesh. The same colour will not print identically on both unless it is matched as a set.
Ask for the panels to be checked together - left and right leg, side panels, groin panel and upper - rather than one at a time. A black that reads neutral on the leg can read blue on the mesh if the base fabrics differ.
Trim adds another variable. Gripper silicone, binding tape, reflective strips and thread all need a reference, especially on a two-colour bib where the accent repeats across the leg and waist.
What changes between lots
Yarn lots, dye baths and heat-press conditions all move colour slightly. The purpose of a tolerance is to define how much movement is acceptable before a lot is rejected, rather than expecting an exact numerical match on every roll.
During production, fabric is checked for shade, weight and hand-feel against the approved swatch before cutting. If a lot sits outside the tolerance, it is raised before it becomes a finished garment.
The same record protects a repeat order. The second run is compared with the approved swatch, not with a photograph of the first delivery. Send references through the contact page, or start from the colourways in the catalog.