Dye sublimation
Dye sublimation prints artwork into polyester fabric using heat and pressure. The dye becomes part of the fibre, so the surface stays flat and breathable instead of carrying a printed film.
It is the natural choice for bib short graphics: gradients, camo, geometric side panels, sponsor blocks and designs that run edge to edge. On bib short leg panels, mesh uppers and gripper bands, it is the method that allows a complete design without adding weight.
The limits are practical. Sublimation works on polyester, and the final colour depends on the base fabric shade. Very fine detail can soften on textured mesh or a high-stretch knit, so artwork should be tested on the actual substrate before bulk.
Embroidery on stretch panels
Embroidery builds a graphic from thread and stitching. It suits crests, wordmarks and small sponsor marks on a woven label or a low-stretch trim, where the surface does not move with the leg panel.
On a compressive bib short, embroidery has to be placed with care. Thread and backing add weight and limit stretch, so a dense logo on the thigh can pucker when the rider is in position. Placement, stitch count and backing are approved on the sample.
Where a raised mark is wanted on a high-stretch panel, a silicone or heat-transfer badge usually behaves better than dense stitching.
Silicone: gripper and badge
Silicone appears twice on a bib short. As a gripper, it is printed or bonded to the inside of the leg opening to stop the short riding up. As a crest, it is a raised rubberised badge with a clean edge.
As a gripper, the pattern matters: dot, wave and stripe layouts behave differently on the skin and against the fabric. The approved sample defines the pattern, the width and the position on the leg.
As a badge, silicone gives a modern three-dimensional look that suits a bib short side panel or a retail capsule. Both uses depend on the substrate, so wash testing belongs on the approval sample, not on the bulk order.
Reflective and foil accents
Reflective transfer adds visibility for low-light training and commuting. It reads best as a defined accent - a strip above the gripper, a logo on the outer thigh, a rear-facing band - rather than as an all-over finish that stiffens the panel.
Foil adds a metallic surface for crests or sponsor marks. It reads best against a matte base: a gold wordmark on a black bib, or a fine foil line above the gripper.
Both are applied after the garment is cut, and both depend on the substrate. A textured mesh, a coated pocket panel or a stretch leg panel can change how the bond behaves, so the placement is fixed on the sample.
How to choose per panel
Start with the job the decoration has to do:
- All-over design: dye sublimation.
- Raised crest on a low-stretch panel: embroidery or silicone.
- Short that must stay put: silicone gripper at the leg opening.
- Low-light visibility: reflective transfer accents.
- Metallic sponsor mark: foil.
Then check the fabric. A 200 GSM race bib, a 240 GSM endurance bib, a mesh bib upper and a reflective leg band all respond differently to heat, stitching and bonding. The approved sample is where the method, placement and colour are fixed for bulk. The capabilities page lists the processes available across the line.